If you want to have a stretch ceiling, but do not want to trust others to install it — do it yourself! Before starting work directly on the ceiling stretch, you need to figure out the lighting of the room: change the wiring, prepare the basics of the lamps. It is important to know that light bulbs for such ceilings should not exceed 50 watts. Then you can start the main work. Getting down to the main work, note that for uninterrupted construction you need diesel fuel with delivery.
To fix the profile, it is necessary to determine where the lowest point of the ceiling is. From this point, you should retreat the desired distance and using a level, draw a horizontal line around the entire perimeter. To begin with, the profile is simply glued, and then fastened with screws. The gap between them can be 8 cm. Then it is necessary to heat the room to 40 ° C and maintain this temperature until the completion of all work on the installation of the stretch ceiling. Using a building hair dryer, the film canvas should be heated to 60 ° C and stretched to the desired size. It is necessary to fix the canvas in opposite corners of the room. The last anchoring angle is the most difficult. It is necessary to fix the film in the profile with an interval of 8 cm, then, using a spatula, fix the film along the perimeter of the profile, while pulling it evenly.
Cut off the excess web. Straighten the folds with a circular motion blower. It remains only to complete the work on the lighting — and you are done with your job.!