If, during the construction of the foundation, metal reinforcement is used, that is, to reinforce the foundation, then by doing so you will protect it from the appearance of cracks and make the entire structure a single whole. In addition, thanks to the reinforcement of the foundation, you will be able to reduce its subsidence, and, therefore, by reducing the subsidence of the foundation, you will reduce its deformation..
The reinforcement process itself consists in creating a frame of reinforcement around the entire perimeter of the trench. As for the frame, it consists of rectangles that are connected at the corners of the building. The frame itself should be already 10 cm from the width of the trench, and located in the middle so that the gap on the sides is the same. For the reinforcement of the foundation, it is worth using only one-piece reinforcement, since the strength of the foundation will depend on it..
It is best to fasten the reinforcement bars with a knitting wire, but it is highly discouraged to use welding for fastening. When reinforcing the foundation, do not forget about its protection. Parchment is used as a protective material for the foundation, which is attached to the inner walls of the formwork. Also, the smooth surface of the parchment will make the walls of the foundation even and smooth after pouring, thereby you can reduce the cost of finishing the basement of the foundation..
————————————————————————————
If, when digging a ground for the foundation, your technique is half-hearted, we advise you to contact a specialized organization — a car service station.